Poulan COGT22H48A manual To Remove Mower, To Install Mower

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

1. Depress brake pedal fully and set parking brake.

2.Place attachment clutch in “DISENGAGED” position.

3.Turn ignition key to “STOP” and remove key.

4.Make sure the blades and all moving parts have completely stopped.

5.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER			attachment lift control. Engage parking
1. Place attachment clutch in “DISEN-			brake.
GAGED” position.			1. Swing anti-sway bar to left side of
2. If equipped, turn height adjustment				mower deck.
knob to lowest setting.			2. Slide mower under tractor with deflec-
3. Lower mower to its lowest position.				tor shield to right side of tractor.
4. Disengage belt tension rod from lock			IMPORTANT: Check belt for proper rout-
bracket.			ing in all mower pulley grooves.
CAUTION: Rod is spring loaded. Have			3. If equipped, turn height adjustment
a tight grip on rod and release slowly.				knob counterclockwise until it stops.
5. Remove retainer spring holding			4. Lower mower linkage with attachment
anti-swaybar to chassis bracket and				lift control.
disengage anti-sway bar from bracket.			5. Be sure belt tension rod is in disen-
6. Remove four retainer springs from front				gaged position.
plate assembly and remove plate.			6. Install belt into electric clutch pulley
7. Remove retainer springs from suspen-				groove.
sion arms at deck and disengage arms			7. Place the suspension arms on outward
from deck.				pointing deck pins. Retain with double
8. Raise attachment lift to its highest posi-				loop retainer spring with loops up as
tion.				shown.
9. Slide mower forward and remove belt			8. Install front plate assembly to tractor
from electric clutch pulley.				suspension brackets and retain with
10. Slide mower out from under right side				single loop retainer springs as shown.
of tractor.			9. Position front plate assembly between
TO INSTALL MOWER				front mower brackets. Raise deck and
Be sure tractor is on level surface and				plate assembly to align holes and
mower suspension arms are raised with				insert flanged pins. Secure pins with
	Lock Bracket	Front		double loop retainer springs between
				the plate assembly and mower brack-
Belt Tension		Mower
				ets.
Rod		Bracket
(Disengaged		Electric Clutch
Position)					Double Loop
		Pulley
					Retainer Springs
Chassis					Front Plate
					Assembly
Bracket
Retainer					Single Loop
Spring
					Retainer Springs
Anti-Sway					Flanged Pins
Bar
					Front Mower
USE PLIERS FOR
					Bracket
RETAINER SPRINGS
	Suspension Arms
Loop Up	Double Loop
	Retainer Springs
	(Outward pointing				Deflector Shield
	deck pins)	23
				02565