SERVICE AND ADJUSTMENTS
RETAINER |
|
| |
SPRING |
|
| |
DRIVE BELT TEN- |
|
| |
SION HANDLE |
|
| |
ENGINE PULLEY |
| TRANSAXLE | |
| PULLEY | ||
BELT KEEPER | |||
| |||
| FLAT IDLER |
| |
|
| BELT | |
BELT | BELT | KEEPER | |
| |||
KEEPER | KEEPER | CLUTCHING | |
CLUTCHING | FLAT IDLER | ||
| IDLER |
| |
FIG. 27
TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 28)
The motion control lever has been preset at the factory and adjustment should not be necessary.
•Park tractor on level surface. Stop tractor by turning ignition key to “OFF” position and engage parking brake.
•Loosen the adjustment bolt in front of the right rear wheel.
•Move motion control lever to the neutral position (N).
•Tighten the adjustment bolt.
ADJUSTMENT
BOLT
FIG. 28
TRANSMISSION REMOVAL/REPLACEMENT
Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See“PURGETRANSMISSION” in the Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGN- MENT
If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 29)
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal.
•Repair tire and reassemble.
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
REAR WHEEL -
•Block rear axle securely.
•Remove five (5) hub bolts to allow wheel removal.
•Repair tire and reassemble. Replace and tighten hub bolts securely.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
WASHERS
RETAINING
RING
AXLE
COVER
00663
FIG. 29
24
