To Replace Headlight Bulb, To Replace Fuse | Poulan PDGT26H48A

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedures.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02141

FIG. 32

26

Image 26

Poulan PDGT26H48A owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Contents

PDGT26H48A General Operation IV. ServiceSafe Operation Practices for RIDE-ON Mowers II. Slope Operation Table of Contents Product Specifications Customer Responsibilities Unassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from Carton Install Seat See Fig Assemble Gauge Wheels to Mower Deck See Fig Install Mower and Drive Belt See Figs To Attach Nose Roller See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Operation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See Figs ADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See Fig Mowing Tips Purge Transmission Before Each USE MaintenanceGeneral Recommendations Tractor Engine Muffler CleaningClean AIR INTAKE/COOLING Areas Spark Plugs To Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level Mower Housing FRONT-TO-BACK Adjustment See Figs To Replace Mower Drive Belt To Replace Mower Blade Secondary Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check and Adjust BrakeTo Adjust Attachment Clutch See Fig To Adjust Steering Wheel ALIGN- Ment Transaxle Motion Control Lever Neutral Adjustment See FigTransmission REMOVAL/REPLACEMENT Front Wheel TOE-IN/CAMBER To Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse Order Interlocks and Relays To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb To Replace Fuse To Adjust Carburetor To Adjust Throttle Control Cable See FigTo Adjust Choke Control See Fig Engine OIL OtherFuel System Cylinders Troubleshooting Points Problem Cause Correction OFF Schematic Tractor Model Number PDGT26H48A, Product Number 954 56 Electrical KEY Part Description Chassis and Enclosures 138 Repair Parts Ground Drive 153 Transaxle Hydro Gear Steering Assembly 180656 Wheel, Steering Engine Spark Arrester KIT Seat Assembly Decals Wheels & Tires Lift Assembly Mower Deck KEY Part NO. NO. Description Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX Parts and Service