Primer bulb
ON/OFF Switch
Starter
Handle
Choke Lever
Muffler
S Squeeze the throttle trigger fully and hold through all remaining steps.
SPull starter rope handle sharply 6 times. S Move choke lever to HALF CHOKE posi-
tion.
S Pull starter rope handle no more than 6 pulls, until engine runs.
S Allow engine to run 10 seconds, then move choke lever to the OFF CHOKE position.
STARTING A WARM ENGINE
SMove the ON/OFF switch to the ON posi-
tion.
SMove choke lever to the OFF CHOKE posi- tion.
SPull starter rope handle until engine runs. S If engine does not start in 5 pulls, follow in- structions in STARTING A COLD ENGINE.
S Do not change the engine governor set- tings or over speed the engine.
SIf the product vibrates abnormally, immedi-
ately stop the engine and check for the cause. Vibration is generally a warning of trouble.
S Stop the engine whenever you leave the operating position; disconnect the spark plug lead before unclogging the cutting blade guard, when making a repair, adjust- ment, inspection, or the like.
S Operate product from position where guards block the line of sight to the cutting blade.
the blade continues to stall, stop the engine, disconnect the spark plug, and inspect for blockage or damage.
WARNING: Keep the blade area clean. Always release the throttle trigger, move the ON/OFF switch to the OFF position, disconnect the spark plug, and make sure the blade has completely stopped turning before cleaning.
SETTING THE DEPTH OF THE WHEEL
WARNING: Never attempt to adjust the wheel when the engine is running. Always stop the engine, wait until the blade stops turning and disconnect the spark plug before making adjustments.
SLoosen plastic knob on the blade guard.
SRaise or lower the wheel to obtain desired edging depth.
STighten knob hand tight.
NOTE: If area has not been edged for sever- al weeks, do not cut deeper than 1/2 inch the first time.
We recommend all service and adjustments not listed in this manual be performed by an Authorized Service Dealer.
BLADE REPLACEMENT
WARNING: The blade will continue to spin after the engine stops or after the throttle trigger has been released. To avoid serious injury, make sure the blade has stopped coasting and disconnect the spark plug before performing work on the blade.
WARNING: Wear protective gloves when handling or performing maintenance on the blade to avoid injury. The blade is sharp and can cut you even when it is not moving.
EDGING
As you become familiar with use of your edger attachment, you will be able to determine your own operating pace. Conditions such as depth of cut and material being cut will regu- late the speed and time required for your edg- ing job.
SAllow the engine to warm up before you begin
edging.
SIncrease the engine speed before placing the blade in the cut. For best results, run the en- gine at full throttle while cutting.
S Always work going away from people and solid objects such as walls, large stones, trees, automobiles, etc.
SBe careful when edging near trees or valuable plants. The high speed metal blade may cut
roots and cause damage to the plants.
SIf the blade stalls, immediately move the unit back slightly to allow the blade to restart. If
5
Locking Lever
STo remove the blade, push in locking lever and hold.
SRotate blade nut until the locking lever falls
into one of the grooves in the dust cup.
S Continue to hold in locking lever. This will keep the shaft from turning while loosening the blade nut.
SRemove the blade nut by turning clockwise. S Remove both washers and the blade from
