Poulan PO10527ESA owner manual Meets A.N.S.I. Safety Requirements

OPERATION

SPARK

PLUG

SAFETY

IGNITION

KEY

CHOKE

CON-

TROL

THROTTLE

/ENGINE

CONTROL

RECOILPOWER

(AUXILIARY) CORD

STARTERPLUG HANDLE

PRIMER

NOTE: ITEMS ABOVE

ARE SHOWN IN

THEIR TYPICAL

LOCATION ON THE

ENGINE. ACTUAL

LOCATION MAY VARY

WITH THE ENGINE

ON YOUR UNIT.

AUGERS

	ENGINE OIL CAP	AUGER	DISCHARGE CHUTE CONTROL LEVER
	WITH DIPSTICK	CONTROL		DEFLECTOR REMOTE
		LEVER	DRIVE SPEED
				CONTROL LEVER
			CONTROL LEVER
	GASOLINE
	FILLER
	CAP			TRACTION
		CHUTE
				DRIVE
	DEFLECTOR
				CONTROL
				LEVER
	OIL
	DRAIN
	PLUG
	DISCHARGE			LIGHT
	CHUTE
ELECTRIC
START	FUEL SHUT-			HANDLE
BUTTON	OFF VALVE			KNOB
	CLEAN-OUT TOOL
				MUFFLER
				TOOLBOX

SKID PLATE

FIG. 10

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox - used to store spare shear bolts, locknuts and		Drive speed control lever - used to select forward or
wrench.		reverse motion and speed of snow thrower.
Safety ignition key - must be inserted for the engine to		Traction drive control lever - used to engage power-pro-
start and run. Remove when snow thrower is not in use.		pelled forward or reverse motion of snow thrower.
Electric start button - used for starting the engine.		Auger control lever - used to engage auger motion (throw
Recoil (auxiliary) starter handle - used for starting the		snow).
		Discharge chute control lever - used to change the di-
engine.
Primer - pumps additional fuel from the carburetor to the		rection the snow is thrown.
		Deflector remote control lever - used to change the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.		distance the snow is thrown.
		Skid plate - used to adjust height of scraper bar from the
Throttle/engine control - used to select either FAST or
		ground.
SLOW engine speed and to STOP the engine.	9