11
SFormowingor sweeping, us e full throttle for
agood c lean job.
TRIMMING --Hold the bottom of the trimmer
headabout 3 inches (8 cm) abov e theground
andat an angle. Allow only the tip of the line to
make contact. Do not force trimmer line into
work area.
Trimming
3inc hes (8 cm)
above ground
SCALPING -- The scalping technique re-
moves unwanted vegetation down to the
ground. Hold the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
atan angle. Allow the tip of the line to str ike the
groundaround trees, posts, monuments ,etc .
This technique increases line wear.
Scalping
MOWING --Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING-- The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: Dis connect the spark
plug before performing maintenance except
for carburetor adjustments.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in theins truction
manual performed by an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work on the
product, Poulan PRO may not pay for
repairs under warranty. It is your re-
sponsibility to maintain and perform
general maintenance.

CHECK FOR LOOSE

FASTENERSAND PARTS

SSpark Plug Boot
SAir Filter
SHousing Screws
SAssist Handle Screw
SDebris Shield

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for re-
placement of damaged or worn parts.
SON/OFFSwitch -- EnsureON/OFF switch
functions properly by moving the switch to
theOFF pos ition. Make sure engine stops;
thenr estart engine and continue.
SFuel Tank --Discontinue use of unit if fuel
tank shows signs of damage or leaks.
SDebris Shield -- Discontinue use of unit if
debris shield is damaged.

INSPECT AND CLEAN UNIT AND

LABELS

SAfter each use, inspect complete unit for
looseor damaged parts. Cleanthe unit and
labelsusing a damp c loth with a mild deter-
gent.
SWipe offunit with a c lean dry cloth.

CLEAN AIR FILTER

A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
1. Cleanthe cover and the ar ea around it to
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Remove parts by pressing button to re-
lease air filter cover.
NOTE: Toav oid creating a fire hazard or
producingharmful ev aporative emissions, do
notc leanf ilter in gasoline or other flammable
solvent.
3. Washthe filter in soap and water.
4. Allowfilter to dry.
5. Replaceparts.