REPLACING THE TRIMMER HEAD

1.Hold the dust cup with a wrench to keep the shaft from turning while removing and installing trimmer head.

Dust Cup

2.Remove trimmer head by turning coun- terclockwise (looking from bottom of unit).

3.Thread replacement trimmer head onto the shaft by turning clockwise. Only tighten hand tight!

CARBURETOR IDLE SPEED ADJUSTMENT

WARNING: Keep others away when making idle speed adjustments. The trimmer head or any optional attachment will be spin- ning during most of this procedure. Wear your protective equipment and observe all safety precautions. After making adjustments, the trimmer head or any optional attachment must not move/spin at idle speed.

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is released.

S The trimmer head or any optional attachment moves/spins at idle.

Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.

To adjust idle speed:

Allow engine to idle. Adjust speed until engine runs without trimmer head or any optional at- tachment moving or spinning (idle too fast) or engine stalling (idle speed too slow).

STurn idle speed screw clockwise to increase

engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed if trimmer head or any optional attachment moves or spins at idle.

WARNING: Recheck the idle speed after each adjustment. The trimmer head or any optional attachment must not move or spin at idle speed to avoid serious injury to the operator or others.

Idle speed screw

Air filter cover

If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer or call 1--800--554--6723.

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric

motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container.

Follow the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

16

Page 15 Page 17
Page 16
Image 16
Poulan PPB330 Replacing the Trimmer Head, Carburetor Idle Speed Adjustment, Seasonal Storage, Fuel System, Porting
Page 15 Page 17

545186798, PPB330 specifications

The Poulan PPB330,545186798 is a powerful and versatile addition to any homeowner's landscaping arsenal. This string trimmer is designed to make yard maintenance tasks easier and more efficient, catering to both novice users and seasoned gardeners alike.

One of the standout features of the PPB330 is its robust 33cc 2-cycle engine. This powerful engine delivers sufficient power to tackle thick weeds and tough grass with ease. The trimmer is built to handle a variety of tasks, from edging along sidewalks to trimming around flower beds, ensuring that your yard remains impeccably manicured.

Another notable characteristic of the Poulan PPB330 is its lightweight design. Weighing in at just over 10 pounds, this trimmer is easy to maneuver and reduces user fatigue during extended periods of use. The ergonomic handle design enhances comfort and control, allowing for precise cutting and trimming without straining the body.

The PPB330 is equipped with a dual-line feed system, which allows for quick and easy line replacement. This feature ensures that users can continue working without extensive downtime. Additionally, the trimmer has a 17-inch cutting width, making it efficient for tackling larger areas in less time. This combination of power and efficiency makes the PPB330 an ideal choice for homeowners with sizable lawns.

The Poulan PPB330 also incorporates technology designed to reduce emissions and improve fuel efficiency. With its environmentally friendly design, users can feel good about their choice in landscaping equipment. The low-vibration technology helps minimize user fatigue, providing a smoother operation and an enjoyable trimming experience.

Ease of use is a hallmark of the Poulan PPB330, featuring a spring-assist starting system for quick ignition. This means that even those who may not be familiar with operating a string trimmer will find it user-friendly.

In summary, the Poulan PPB330,545186798 stands out as a reliable and efficient string trimmer. Its powerful engine, lightweight design, dual-line feed system, and environmentally friendly technologies make it an excellent choice for anyone looking to maintain a beautiful yard effortlessly. Whether you are edging, trimming, or tackling overgrown areas, the PPB330 is built to deliver superior performance and convenience.
Top Page Image Contents