English-23
CONTROLS
12. Cutting height pedal
The deck cutting height is obtained by
pressing the foot pedal forward to lift the
deck. To lower the deck, you apply pressure
to the top side of the foot pedal and allow it to
pivot while allowing the lift arm to rotate to the
rear of the unit. To stop in a desired cutting
position, rotate the foot pedal down into the
notch in the height plate. The cutting height
range is from 1 1/2" (38 mm) to 5" (127 mm)
in 1/2" (13 mm) increments. The heights are
measured from the ground up to the blade tip
with the engine not running
.
Accessories
For mulching, there is a BioClip attachment
available. This is mounted underneath the
mower deck and consists of discharge cover
and blades.
4 1/2
4
3 1/2
3
2 1/2
2
1 1/2
8011-753
Cutting height pedal
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all
four tires is the same 15 psi (1 bar).