OPERATION

Moving by Hand

When pushing or pulling the mower, be sure to engage the EZT (Integraded Zeroturn Transaxle) bypass linkages. The EZT bypass linkages are located on the rear of the frame.

Raise the deck into the highest cutting position.

Pull the EZT bypass linkages out and into the slots and release so that it is held in the bypass position.

To reengage the EZT’s to drive, reverse the above procedure.

Load machine into truck or trailer by driving up ramps in low gear. DO NOT LIFT! This machine is not intended to be lifted by hand.

8011-721

1.EZT Bypass linkages Bypass linkages

8011-722

1.Head outside of rear deck

2.EZT Bypass linkage in bypass position Bypass position

English-33

Page 35
Image 35
Poulan Pro 925 ZX, Pro 950 ZX manual Moving by Hand