Manuals / Poulan / Lawn and Garden / Tiller

Poulan PRRT9000 warranty CONNECT SHIFT ROD See Fig, Remove Tiller From Crate, Check Tire Pressure

Models: PRRT9000

1 20

Download 20 pages 31.8 Kb

Page 6

Image 6

ASSEMBLY

CONNECT SHIFT ROD (See Fig. 6)

•Insert end of shift rod into hole of shift lever indicator.

•Insert hairpin clip through hole of shift rod to secure.

SHIFT	HAIRPIN	SHIFT
	CLIP	LEVER
ROD
		INDICATOR

Fig. 6

REMOVE TILLER FROM CRATE

•Make sure shift lever indicator is in “N” position (See Fig. 6)

•Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield.

•Rotate tiller handle to the right and pull tiller out of carton.

CHECK TIRE PRESSURE

The tires on your unit were overinflated at the factory for shipping purposes. Correct and equal tire pressure is important for best tilling performance.

•Reduce tire pressure to 20 PSI (1.4 kg/cm2).

HANDLE HEIGHT

•Handle height may be adjusted to better suit operator. (See “TO ADJUST HANDLE HEIGHT” in the Service and Adjustments section of this manual).

Page 6

Image 6

Poulan PRRT9000 warranty CONNECT SHIFT ROD See Fig, Remove Tiller From Crate, Check Tire Pressure, Handle Height, Assembly

Contents

REAR TINE TILLER OPERATORS MANUAL MODELIMPORTANT MANUAL ALWAYS WEAR EYE PROTECTION DURING OPERATIONMAINTENANCE AND STORAGE SAFETY RULESSafe Operation Practices for Walk-Behind Powered Rotary Tillers TRAININGCUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS 11-13CONTENTS OF HARDWARE PACK ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY OPERATOR’S POSITION See FigUNPACKING CARTON See Fig INSTALL HANDLE See Figs. 3, 4, andstaples when handling or disposing of Be careful of exposedCHECK TIRE PRESSURE CONNECT SHIFT ROD See FigREMOVE TILLER FROM CRATE HANDLE HEIGHTOPERATION READ THIS MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLERMEETS ANSI SAFETY REQUIREMENTS KNOW YOUR TILLERTINE OPERATION - WITH WHEEL DRIVE HOW TO USE YOUR TILLERSTOPPING See Fig FORWARD - WHEELS ONLY/TINES STOPPEDTO TRANSPORT GAGED” position when starting engineBEFORE STARTING ENGINE CHECK ENGINE OIL LEVEL See Fig.11TILLING HINTS TINE SHEAR PINSCULTIVATING OPERATIONLUBRICATION CHART MAINTENANCEMAINTENANCE SCHEDULE GENERAL RECOMMENDATIONSDo not touch hot muffler or cylinder fins as contact may cause burns AIR CLEANER See FigENGINE TO CHANGE ENGINE OIL See Figs. 15 andMUFFLER CLEANINGCOOLING SYSTEM See Fig SPARK PLUGTILLER SERVICE AND ADJUSTMENTSTO ADJUST HANDLE HEIGHT See Fig TIRE CAREGROUND DRIVE BELT ADJUSTMENT See Fig TO REPLACE GROUND DRIVE BELT See Fig. 21 andSERVICE AND ADJUSTMENTS TINE REPLACEMENT See Figs. 23, 24 and SERVICE AND ADJUSTMENTSTO ADJUST CARBURETOR SERVICE AND ADJUSTMENTSENGINE FUEL SYSTEM STORAGEOTHER ENGINE OILTROUBLESHOOTING POINTS LIMITED WARRANTY Mississauga, Ontario