4 CONTAINER MOUNTING (See Fig. 4)
1.Install one container to left side fi rst with warning to outside of unit. Install another container to center position and one in right position.
NOTE: Right container should always overlap left container at center supports.
2. Close cover and lock latch handles over center support
tubes.COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER |
|
SUPPORT |
|
TUBES |
|
| NING |
| WAR |
CONTAINER | 03022 |
HANDLE |
|
| NING |
| WAR |
CONTAINER
WARNING
FIG. 4
5 LOWER CHUTE (See Fig. 5)
1.Raise and hold deflector shield in upright position.
2.Place slot in lower chute over tab on mower deck and position lower chute over deck opening as shown.
3.Hook rear latch into fl ange hole on back of mower deck.
4.Hook front latch into tab hole on front of mower deck.
CAUTION: Do not remove deflector shield from mower. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation.
DEFLECTOR
SHIELD
OPTIONAL FRONT
GAUGE WHEEL
6 UPPER CHUTE (See Figs. 6A & 6B)
1.Lower mower to its lowest cutting position.
2.Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger indicator.
3.Push in and turn upper chute until it is in line with lower chute.
4.Align the bosses on lower chute with alignment slots on upper chute and slide together.
5.Secure with rubber latch by hooking hole in latch over latch pin.
|
| FULL BAGGER |
|
COVER | UPPER | INDICATOR | HANDLE |
CHUTE |
| ||
|
|
|
LOWER
CHUTE
03029
FIG. 6A
ALIGNMENT
SLOT
LATCH PIN
03023 | RUBBER |
| LATCH |
BOSSES
FIG. 6B
02552
TAB
FRONT
LATCH
REAR LATCH
7 LEVEL MOWER DECK
Be sure deck is properly leveled for best mower performance. See your tractors owner's manual for instructions.
FIG. 5 | 7 |
