SRemove wing nut from shield.
SInsert bracket into slot on shield.
SPivot shield until bolt passes through hole in
bracket.
SSecurely tighten wing nut onto bolt.
STARTING A COLD ENGINE (or a warm engine after running out of fuel)
SSet unit on a flat surface.
Bracket
Slot
Shield
Wing Nut
SMove choke lever to FULL CHOKE posi- tion.
S Squeeze the throttle trigger fully and hold through all remaining steps.
SPull starter rope handle sharply 6 times. S Move choke lever to HALF CHOKE posi-
tion.
S Pull starter rope handle no more than 6 pulls, until engine runs.
S Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position.
STARTING A WARM ENGINE
WARNING: Remove fuel cap slowly when refueling.
This engine is certified to operate on un- leaded gasoline. Gasoline must be mixed with a good quality
3.2ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY.
HOW TO STOP YOUR UNIT
To stop the engine, push and release the en- gine STOP switch. The switch will automati- cally return to the ON position. Wait 5 sec- onds before attempting to restart unit to allow switch to reset.
HOW TO START YOUR UNIT
Starting Position
Choke Lever
Muffler
Trigger
Primer Bulb
WARNING: The trimmer head will turn while starting the engine. Avoid any con- tact with the muffler. A hot muffler can cause serious burns.
SMove choke lever to OFF CHOKE position. S Pull starter rope handle until engine runs. S If engine does not start in 5 pulls, follow instructions in STARTING A COLD EN-
GINE.
OPERATING POSITION
ALWAYS WEAR: |
|
|
| Eye |
|
|
| ||
|
|
|
| Protection |
Long Pants
Heavy Shoes
Cut from your right to your left.
ADVANCING THE CUTTING LINE
Advance line by tapping the bottom of the cut- ting head lightly on the ground while engine is running at full speed. The metal line limiter blade attached to the shield will cut the line to the proper length.
REPLACING THE LINE
SRemove spool by firmly pulling on tap but-
ton.
SClean entire surface of hub and spool.
SReplace with a
ameter Poulan/Weed Eaterr brand line. Never use wire, rope, string, etc., which can break off and become a dangerous missile.
S Insert ends of the lines about 1/2 inch (1 cm) into the small holes on the inside of spool.
4