Poulan TE 500 CXL manual Troubleshooting Table, Cause, Remedy

Models: TE 500 CXL

1 7
Download 7 pages 18.87 Kb
Page 6
Image 6
TROUBLESHOOTING TABLE

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit.

TROUBLE

CAUSE

REMEDY

Engine will not

S

ON/OFF switch in OFF

S

Move ON/OFF switch to ON.

start.

 

position.

 

See “Starting.”

 

S

Engine flooded.

S

 

S

Fuel tank empty.

S

Fill tank with correct fuel mixture.

 

S

Spark plug not firing.

S

Install new spark plug.

 

S

Fuel not reaching carburetor.

S

Check for dirty fuel filter; replace.

 

 

 

 

Check for kinked or split fuel line;

 

 

Carburetor requires adjustment.

 

repair or replace.

 

S

S

See “Carburetor Adjustments.”

Engine will not

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

idle properly.

S

Throttle trigger screw too

S

Loosen screw.

 

 

tight.

 

 

Engine will not

S

Air filter dirty.

S

Clean or replace air filter.

accelerate,

S

Spark plug fouled.

S

Clean or replace spark plug; re-gap.

lacks power,

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

or dies under

 

 

 

 

a load.

 

 

 

 

Engine

S

Fuel mixture incorrect.

S

Empty fuel tank and refill with

smokes

 

Air filter dirty.

 

correct fuel mixture.

excessively.

S

S

Clean or replace air filter.

 

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

Line does not

S

Line improperly routed in head.

S

Check line routing.

advance or

S

Line improperly wound on

S

Rewind line tightly and evenly.

breaks while

 

spool.

 

Use only 0.080” (2 mm) dia. line.

cutting.

S

Line size incorrect.

S

Line welds

S

Line size incorrect.

S

Use only 0.080” (2 mm) dia. line.

onto spool.

S

Incorrect spool.

S

Replace with correct spool.

 

S

Line is being crowded against

S

Cut with tip of line fully extended.

 

 

material being cut.

 

 

Line pulls

S

Too little line outside of head.

S

Remove spool and pull 4 inches

back into

 

 

 

(10 cm) of line outside of head.

head.

S

Line size incorrect.

S

Use only 0.080” (2 mm) dia. line.

 

 

 

 

 

ELECTROLUX HOME PRODUCTS NORTH AMERICA, Division of WCI Outdoor Prod- ucts, Inc. warrants to the original purchaser that each new Weed Eater brand gasoline tool or at-

tachment is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline prod- uct or attachment as follows from the original date of purchase.

2 YEARS - Parts and Labor, when used for household purposes.

90 DAYS - Parts and Labor, when used for commercial, professional, or income producing purposes.

30 DAYS - Parts and Labor, if used for rental purposes.

This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not specifically

recommended by ELECTROLUX HOME PRODUCTS NORTH AMERICA for this tool.

Additionally, this warranty does not cover tune- ups, spark plugs, filters, cutting line, or rotating head parts that will wear and require replace- ment with reasonable use during the warranty period. This warranty does not cover predeliv- ery setup or normal adjustments explained in the operator’s manual.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EX- PRESSLY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, SO THE ABOVE

6

Page 6
Image 6
Poulan TE 500 CXL manual Troubleshooting Table, Cause, Remedy