ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.
WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on the unit.
DA standard screwdriver is required for as- sembly.
BLOWER TUBE ASSEMBLY
1.Align the rib on the blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: Knob must be loose enough to allow blower tube to be inserted in blower outlet. Loosen knob by turning counterclockwise.
Blower
Outlet Blower
Tube
Groove
Rib
2.Secure the tube by turning the knob clock- wise.
3.To remove the tube, turn the knob counter- clockwise to loosen the tube; remove the tube.
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow tube through the small opening in the bag.
Elbow
TubeSmall
Opening
Zipper 
OpeningRib
NOTE: Make sure edge of the small opening is flush against the flared area of the elbow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tube from engine.
Rib
Groove
5.Insert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the blower outlet groove.
6.Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury.
1.Align the lower vacuum tube as shown. Push lower vacuum tube into upper vacu- um tube.
Upper Vacuum
Tube
Lower Vacuum Tube
2.Insert the tip of a screwdriver into the latch area of the vacuum inlet.
Latch | Blower | |
Outlet | ||
Area | ||
| Latch Area | |
| Vacuum | |
| Inlet Cover |
3.Gently tilt the handle of the screwdriver to- ward the back of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.
4.Hold the vacuum inlet cover open until up- per vacuum tube is installed.
Vacuum Inlet
Retaining Post
Vacuum
Inlet
Cover
