Power Acoustik OVN1-1800D, OVN2-600, OVN2-2200, OVN4-1600, OVN4-840 Controls, RCA input jacks

CONTROLS

RCA input jacks

These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.

Auxiliary outputs

The Auxiliary outputs offer Power Acoustik amplifiers easy, unlimited system expansion.

Route RCA's from the line out of the first amplifier to the line input of a second amplifier when using a single source output.

LEVEL Control

The level control will match the amplifiers sensitivity to the source units signal voltage. OVN2-600/OVN4-840/OVN4-1200/OVN4-1600 OVN1-1800D/OVN1-3000D/OVN1-4000D/OVN1-5500D : The Operating range is 200mV minimum to 6V maximum. OVN2-800/OVN2-1250/1800/2200 : The Operating range is 200mV minimum to 3V maximum.

CAUTION: Do not run the amplifier in high volume for long time, otherwise the loudspeakers will be damaged.

Bass EQ / BASS BOOST OVN2-600/OVN4-840/OVN4-1200/OVN4-1600 : The boost can be selected 0dB or 18dB. OVN2-800/OVN2-1250/OVN2-1800/OVN2-2200 : The boost can be adjusted between 0dB to 24dB. OVN1-1800D/OVN1-3000D/OVN1-4000D/OVN1-5500D : The boost can be adjusted between 0dB to 18dB.

Full pass x-over switch

When the switch is in the "Full" position, full range signal is passed.

HPF X-over switch

When the switch is in the "HPF" position, frequencies higher than the high pass frequency setting are passed.

LPF X-over switch

When the switch is in the "LPF" position, frequencies lower than the low pass frequency setting are passed.

- 5 -