CONTROLS

REMOTE

LED

Will illuminate GREEN to indicate the amplifier is on and operating normally, and will be illuminated RED if the amplifier shuts down due to short circuit, DC offset, or overheating detected by on board protection circuitry.

REMOTE

Controls the subwoofer amplifier gain, from a remote location for ease of adjustment during listening.

Warning: Do not connect a level control knob from other manufacturers to the Remote Sub Level Control of any amplifier. Even though the connectors fit properly, the control knob and connector pin positions may be different and the amplifier will be damaged.

PHASE

0°or180° selectable for switching the phase of the output to the woofer.

MASTER/SLAVE MODE[OVN1-1800D/3000D/4000D/5500D] Controls whether the amplifier is a slave or master when connected in combined amplifier configurations. (Refer to the Master Mode section of this guide.)

All of the controls will be adjusted by the "Master" amplifier.

-Slave mode : To be switched " Slave mode" when linking one amplifier with another amplifier.

-Master mode : To be switched " Master mode" when only using this single amplifier.

- 7 -

Page 8
Image 8
Power Acoustik OVN1-3000D, OVN2-600, OVN2-2200, OVN4-1600, OVN4-840, OVN2-800, OVN4-1200, OVN1-1800D, OVN1-5500D, OVN2-1250 Led