Unpacking
Remove all contents from the shipping carton and check against the Contents of Shipping Carton below to verify that all items have been received.
Report any damage to your distributor.
Do not discard any shipping material until after the dust collector has been assembled and is running properly.
You will also require either the Filter Bag System or Canister Filter System. These items are packaged separately and are not listed here.
Contents of Shipping Carton
Refer to Figure 3 to identify items
H Base (1)
JCasters (4)
KMotor/Fan Assembly (1)
LInlet Guard (1)
MInlet Port w/ Cap (1)
NLower Gasket (1)
OConnector Tube (1)
PControl Box (1)
RUpper Gasket (1)
SCollector Housing (1)
TSupport Bar (1)
UHandle (2)
VPlate (2)
WSocket Head Cap Screw, M8x12 (4)
--Remote Control w/ batteries (not shown) (1)
--Owner's Manual (not shown) (1)
--Warranty Card (not shown) (1)
Main Hardware Bag contents (Figure 1):
A – M8 x 20 Hex Cap Screws (24)*
B – M6 x 12 Pan Head Flange Screws (8)* C – M8 Flat Washers (34)*
D – M10 Flat Washers (6)* E – M8 Hex Nuts (16)*
F – 3/8" Hex Nuts (4) – on casters
G – M10 Lock Washers (4) – on casters
Cone Assembly and Hardware (Figure 2):
AA– Support Bracket (1)
BB– Cone (1)
CC– M8 x 16 Hex Cap Screw (1)
DD– M8 Flat Washer (1)
EE– M8 Hex Nut (1)
FF– M 6 x 12 Hex Cap Screws (4)
GG– M6 Hex Nuts (4)
Figure 1: Main Hardware Bag contents
*A through E comprise PM1300-BMHP Base Machine Hardware Package
Figure 2: Cone Assembly and Hardware
CCthrough GG comprise DC1100-HP2 Cone Assembly Hardware Package
Tools Required for Assembly
13mm Wrenches or Sockets 14mm Wrench
#2 Cross Point Screw Driver 6mm hex (“Allen”) wrench
7
