Network File Transfers = 99
Gigabit Ethernet Hardware A Gigabit Ethernet (RJ-45) connector labeled NET-1 is located on the rear panel for conventional
network access. No hardware settings are available or needed, as Gigabit Ethernet automatically
negotiates port speed. Connection speed is shown by LEDs on the network connector. The NET-1
port also automatically configures transmit and receive connections, and does not need a
“crossover” cable when connecting directly from one server to another.
Label Indication Meaning
Green on The port is connected to a valid link
partner
Green flashing
Data activity
ACT/LNK
(Left)
Off No link
Off 10 Mbps
Yellow flashing
100 Mbps
10=OFF
100=YELLOW
1000=GREEN
(Right) Green 1000 Mbps
Redundant Server Connection
The Gigabit Ethernet port labeled NET-2 on the Image Server is for redundant (mirrored)
operation of two Image Servers. It does not use FTP protocol, and no connection should be
made from it to other equipment.
Gigabit Ethernet Cable Quality
The high data rates generated by Gigabit Ethernet require high-quality cable designed for this
application. Low-quality network cables can result in high error rates and lower transmission
speed. For Gigabit operation, standard “CAT 5” cable should not be used.
New Category 5e (enhanced) cables ensure maximum transfer rates, and should be used as the
minimum standard. Category 6 cable is a more recent product, designed for applications
where longer cable runs are required.
Configuring Network Settings The Image Server provides a number of user settings that configure it for use as a practical network.
These will be found on the GUI System Network tab shown below.
The NET-1 Ethernet port on the Image Server has a unique IP Address. In this way, each Image
Server can be identified on the network. It also means that there is only one IP Address for a given
volume of data.