Powerware X-Slot USB Module Installing the USB Module, Figure 2. Installing the USB Module, Figure 1. Removing the Single-PortModule

Installing the USB Module

Installing the USB Module

To install the USB module, perform the following steps:

1.Remove the X-Slot cover (or existing X-Slot module) on the UPS rear panel. Retain the screws (see Figure 1).

NOTE UPSs with a single X-Slot may have another X-Slot module already installed (such as the Powerware 9125 UPS). If there is a communication cable attached to this module, disconnect the cable and then remove the X-Slot module.

Figure 1. Removing the Single-Port Module

2.To prevent electrostatic discharge (ESD), place one hand on a metal surface such as the UPS rear panel.

Align the USB module with the slot guides and slide the module into the slot until it is firmly seated.

3.Secure the USB module with the screws removed in Step 1.

Figure 2. Installing the USB Module

4.Connect the USB module cable to the USB port on your computer.

5.Continue to the following section, “Installing the Software.”

6 X-SlotZUSB Module User’s Guide : 05146515 A Uncontrolled Copy