Amplifier Status Leds | Precision Power A500/2, A1000/2, A800/2

AMPLIFIER STATUS LEDS

1 2

The LEDs provide the following indications:

1.Power - These LEDs illuminates the center Precision Power logo background when the amplifier power is turned on.

2.Short - These LEDs behind the PPI logo will flash to indicate a short on the output.

2.Thermal - These LEDs behind the PPI logo will extinguish if the amplifier is in thermal shutdown protection.

Note: Read the AP-IV Protection Circuit section for additional information regarding Short and Thermal protection.

6

Image 7

Precision Power A500/2, A1000/2, A800/2 manual Amplifier Status Leds

Contents

Amplifier Models Table of Contents Features ServiceCongratulations WHAT’S Included CEA Specifications General Specifications Specifications Length Width Height Amplifier Status Leds Wiring TOOLS/PARTS for InstallationPage Ground Wiring Powerlocktm Current Draw Charging System Power Wire Size Powerlock Connectors 1211 Front Plate Diagram END Plate Diagram Advanced Instrumentation Input Inputs Qbass Plustm Qbass Plus Specifications Qbass PLUS/QBASS Remote TC-X Crossover A500/2, A800/2, A1000/2 Crossover Detent Chart High Mass Internal Heatsink Adjusting Input GainAP-IV Protection Circuit Opposite Channel Same Channel Limited TWO Year Consumer Warranty