Precision Power PC2400 owner manual System Diagram One, Mixed Mono Output

SYSTEM DIAGRAM

ONE

Source Unit

Trk 1

Tweeter	Passive	Passive	Tweeter
	Crossover	Crossover

MidRange MidRange

POWERCLASS™ Amplifier

Crossover Off

Passive

Crossover

Subwoofer

Mixed Mono Output

The ability to run stereo speakers while simultaneously running a mono output from the same amplifier is accomplished by running the stereo speakers normally and tapping into the appropriate wires for the "mixed mono" channel (left channel positive for the positive speaker wire and right channel negative for the negative speaker wire). Speaker impedance should be no lower than 2 Ohms on the stereo channels and 4 ohms on the mono channel.

NOTE: Passive crossovers must be used for "mixed mono" operation. Choose a low pass crossover around 100Hz for your subwoofer, then choose a high pass crossover for your stereo channels. The high pass crossover must be at the same or slightly higher frequency than the low pass crossover to maintain the correct impedance. See your PrecisionPower dealer or call 1-800-62POWERfor more information about passive crossovers.

15

BACK TO CONTENTS