page 14
COMMERCIAL PRODUCTS DIVISION
Diagram 5
Loosen upper
handrail clamp.
Upper handrail clamp
12
Upright column support
6. Loosen, but do not remove, the 2 screws in the upper handrail clamp
using the supplied hex key. Diagram 5.
7. Attach the handrails one at a time. Diagram 5. Perform the following steps
on one side at a time.
a. Align the upper and lower portions of the handrail. See Diagram 5, #2.
Important: If you have purchased the Precor Heart Rate “touch” Option,
you will need to connect the cables as shown in the inset in Diagram 5, #2.
b. Insert the lower end of the handrail into the base handrail stub. See
Diagram 5, #2.
Diagram 6
Install the handrails.
Black foam grip
Upper clamp
Display console
12
Lower
handrail stub
Set screw
c. Slide the upper portion of the handrail into the upper clamp until the
black foam grip touches the clamp. See Diagram 6, #1.
d. Obtain 4 set screws from the Hardware kit.
e. Insert the 4 set screws as shown in Diagram 6, #2 and finger tighten.
f. Perform steps a. through e. on the opposite side.
Cable
attachment
exists for
Precor Heart
Rate “touch”
option only.