Stand Assembly
Step 1 | Step 2 |
Determine width of stand feet in relation to the cardio equipment. Use a 7/16 wrench to secure 2 hex screws per leg.
Step 3
Insert plastic base cover over lower vertical tube. Do not fasten down at this time.
Step 5
Insert cable assemblies through upper tube opening and bring out lower tube hole as shown.
3
Insert lower vertical tube over center stub and hand install one 3/16 Allen head screw a few turns into vertical tube. Do not tighten at this time. (Clearance needed for Wires)
Step 4
Insert upper curved tube into lower tube. Do not install bolts until step 5 is performed, then adjust upper tube to desired height and install two Allen screws as shown above.
Step 6
Mount power supply with 2 wire ties to the base assembly. Plug power supply connector into cable previously installed down vertical tube.
