MAG
Ceiling Installation
1. Mounting Surfaces
NOTE: Use a 1/8” drill bit to
Wood studs: Where denoted with the letter ‘A’, mark these locations for wood stud installation.
NOTE: Use a masonry bit to
Concrete surface: Where denoted with the letter ‘B’, mark these locations for concrete installation.
2.Use two (2) #14 x 2” wood screws (supplied) to attach the
ceiling plate to the wooden ceiling stud.
NOTE: For extra security, attach a third wood screw to the middle mounting point (A).
3.Slowly raise the projector toward the upper assembly. Once the projector is close to the upper assembly, MagnaGuide™ Technology will pull the lower assembly into the upper assembly and the locking tab will engage.
WARNING: THE MAGNETS ARE USED FOR GUIDING THE UNIT ONLY! PLEASE MAKE SURE THE TWO (2) M4 X 12MM SCREWS ARE USED TO SECURE THE PROJECTOR.
4.Attach the two (2) M4 x 12mm security screws and star washers that are located on each side of the locking tab.
NOTE: Do not release your hold on the projector until the upper and lower assemblies are engaged and the locking tab is in place.
NOTE: If you choose to use the center mounting point for added security, detach the lower assembly from the ceiling plate by removing the two (2) M6 x 12mm security screws, drive the wood screw in place and reattach the lower assembly and security screws.
M5 Allen
Wrench
M6 x 12mm Security Screw
Concrete Mounting
NOTE: The MAG can be mounted to a ceiling with a minimum 6” thickness. Concrete wedge anchors must be used for concrete installation. It is recommended that ¼” wedge anchors be used. A masonry bit must be used to drill the pilot hole. These items can be purchased at your local hardware store.
1.Begin by placing the ceiling plate into position against the ceiling, keeping it level.
2.Mark off four holes to be used for securing the mount and place the ceiling plate aside.
3.Next, drill holes using the appropriate masonry bit for your anchor.
4.Insert a concrete anchor into each hole.
5.If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the ceiling.
6.Once all of the anchors are in place, move the ceiling plate back into position.
7.Attach the nut onto the threaded shaft that is protruding from the ceiling.
8.Do not tighten until all nuts are in place.
Page - 6 - | Installation Manual |