Tilting Lcd Tv Wall Mount, LCD Installation

LCD Installation

1.Determine the mounting hardware that is to be used.

2.If your LCD has a flat back, use the M4x12mm Phillips Head Screws.

NOTE: If your LCD has a recessed back, use the longer M4x30mm Phillips Head Screws and 3/4” Spacers.

3.After you have determined the appropriate screws, use them to attach the mounting plate to the back of your LCD.

4.Do not over-tighten the screws.

Final Installation

1.To complete the installation, simply slide the mounting plate onto the back plate.

2.The plastic tab on the top of the back plate should click, indicating that the mounting plate is secure.

3.If you need to remove the mounting plate, push in on the tab and slide the mounting plate up.

4.For additional security and stability, insert the hex set screw into the hole located on base of the mounting plate and tighten using the supplied Allen Wrench.

Set Screw

Operation and Adjustment

1.Tilt angle can be adjusted by first loosening the adjustment knob.

2.Adjust the tilt to the desired level and re-tighten the knob.

3.Other viewing adjustments can be made by simply moving the elbow joint into the desired position.

NOTE: If you find that a joint is too difficult to move or does not hold the LCD in place, you can adjust the tightness of the joint. This can be done by either tightening the adjustment knob, or by using the supplied Allen wrench and tightening the elbow joint.

Elbow Joint

Slide Plate Down