SAFETY
The safety of all persons installing, using, servicing, or working near the P4 Level Loader unit is of paramount concern to Presto. The P4 Level Loader unit is a powerful machine with moving parts, and is CAPABLE OF CAUSING PERSONAL INJURY IF PROPER PRECAUTIONS ARE NOT TAKEN.
Therefore, throughout this manual, Presto has identified certain hazards which may occur in the use of the P4 Level Loader unit, and provided appropriate INSTRUCTIONS or PRECAUTIONS which should be taken to avoid these hazards. In some cases, Presto has also pointed out the CONSEQUENCES which may occur if Presto’s instructions or precautions are not followed. Presto uses the following system of identifying the severity of the hazards associated with its products:
PLEASE READ AND FOLLOW THIS INSTRUCTION MANUAL, INCLUDING ALL SAFETY INSTRUCTIONS AND PRECAUTIONS, CAREFULLY AND COMPLETELY.
DANGER: Immediate hazard which will result in severe personal injury or death.
WARNING: Hazard or unsafe practice which could result in severe personal injury or death.
CAUTION: Hazard or unsafe practice which could result in minor personal injury or property damage.
INSTALLATION INSTRUCTIONS
Preparation
1.Before you start to install the unit, check for local codes and ordinances which may apply. It is your responsibility to obtain any necessary permits.
2.Read all of these installation instructions carefully. Be sure to read and understand all of the warnings.
3.The unit should be placed indoors, or protected from the weather.
WARNING!
Protect the unit from rain or moisture. If the electrical parts in the power unit get wet, workers may be hurt by electrical shock. The electrical parts may fail if they are wet.
WARNING!
The electric motor can create sparks. Don’t install the unit in an
area where flammable gases may be present.
4.You will need these tools to install the unit:
• A crane or lift truck that can lift the unit safely. If you plan to lag the unit in place, you will need these tools:
• Shims and lag bolts.
• A masonry drill and bit to drill the holes for the lag bolts.
• Wrenches to fit the lag bolts
• Grouting material to fill any spaces under the frame of the machine.
Positioning the Unit
1.Remove the shipping material. Unbolt the lag screws at the lag angles on the corners. (If you plan to bolt the unit in place, leave the lag angles attached to the frame of the unit. Otherwise, unbolt and remove the lag angles.)
2.On the front of this manual, write down the model number, serial number, and date the unit is placed in service. You can find the model number and serial number on the name plate.
4PRESTO P4 LEVEL LOADER OWNER’S MANUAL
