3.During shipping, the platform of the unit is raised
CAUTION!
Always raise the platform and insert the pins before you move the unit. If you try to move the unit in another way, the frame may be bent. Be sure to remove the pins before you operate the unit. If you do not do this, the unit may be damaged. Once the unit has power, raise the platform just a bit to take the load off of the pins, then remove the pins.
4.The unit has an 10' power cord. Choose a location where the cord can reach an outlet easily, without stretching the cord tightly.
5.Move the unit into position, supporting the platform of the unit. Place the unit on a firm, level surface.
CAUTION!
If you place the unit on a surface which is not firm or level, the unit may shift as it operates. You may be hurt, or the unit or load may be damaged.
6.The unit may be operated without bolting the frame to the floor. However, the mounting arrangement is more secure if you use lag screws. Bolt the unit to the floor using four lag bolts. These should run through the lag angles at the corners of the base frame. Insert and tighten the lag bolts to secure the unit. Grout under the base rails to prevent vibration and distortion of the base frame.
Electrical Connections
DANGER!
The unit uses a power supply of 115 volts AC. This voltage can kill you. Don’t work with the electrical parts unless you are a qualified electrician.
PRESTO P4 LEVEL LOADER OWNER’S MANUAL 5
