Pride Mobility owner manual Basic Troubleshooting Instructions JET 3 Ultra

BASIC TROUBLESHOOTING INSTRUCTIONS: JET 3 ULTRA

What if the speed LEDs on the VSI begin to flash?

!Determine if the battery charger is connected to the power base. When the battery charger is connected to the power base, a charger inhibit feature keeps the power chair from driving. This is indicated by the VSI speed LED(s) flashing.

!Determine if the charger harness fuse has blown. A blown charger fuse can cause the charger inhibit to activate.

!Determine if all controller connections are plugged into the power base properly. If the 3-pin charger inhibit connector is not plugged in properly, then the charger inhibit feature will activate.

What if the speed LEDs on the VSI begin to scroll?

!Determine if the VSI has been placed in lock mode. The VSI is equipped with a lock mode feature that prevents unintended use of the power chair. If the VSI is in lock mode, deflect the joystick full forward until it beeps, and then deflect the joystick full rearward until it beeps. The joystick should go back to the drive function.

INFINFB2045/Rev A/12-04-06 www.pridemobility.com 4