Pride Mobility 614 2SP, 614 2HD manual Seatback Angle Adjustment, Armrest Width Adjustment

V . C O M F O R T A D J U S T M E N T S

Seatback Angle Adjustment

If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.

To adjust the seatback angle:

1.Remove the adjusting screws from each seat hinge. See figure 15.

2.Set the seatback at the desired angle.

3.Reinstalltheadjustingscrewstoeachseathingeandtighten.

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

To change the armrest width:

1.Locate the two armrest knobs on each side of the arm- rest receiver bracket. See figure 15.

2.Loosen the knobs.

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 15.

2.Loosen the jam nut.

3.Turn the adjusting screw to raise or lower the front of the armrest.

4.Tighten the jam nut to lock the adjusting screw into place.

Armrest Height Adjustment

To change the armrest height:

1.Loosen the two setscrews located on the armrest receiver. See figure 15.

2.Raise or lower the armrest to the desired height.

3.Tighten the setscrews to secure the armrest.

JAM NUT

ARMREST ANGLE

ADJUSTING SCREW

ARMREST HEIGHT

ADJUSTING

SETSCREWS

SEATBACKANGLE

ADJUSTING SCREW

ARMREST KNOB

Figure 15. Seatback/Armrest Adjustment

Jazzy 614 Series www.pridemobility.com 25