Basic Operation Instructions | 15 |
FAULT CODES
The battery condition meter will flash fault codes when the controller system detects an abnormal condition in the electrical system. All of the battery condition meter LEDs will flash a number of times quickly, then pause, then flash again. The battery condition meter will continue to flash the fault codes until the problem is fixed. The table below identifies the individual fault codes. If any of these fault codes persist, contact your authorized Pride Provider.
Fault | Probable Cause(s) | Possible Solution | |
Code |
|
| |
1 | Flash | The batteries need charging. | Check the battery connections. If the |
|
| There is a bad connection | battery connections are good, then |
|
| to the batteries. | try charging the batteries. |
|
|
|
|
2 | Flashes | There is a bad connection on | Check the left motor connections and |
|
| the left motor. | wiring harnesses. |
|
|
|
|
3 | Flashes | The left motor has a short to | Contact your authorized Pride |
|
| a battery connection. | Provider. |
|
|
|
|
4 | Flashes | There is a bad connection on | Check the right motor connections |
|
| the right motor. | and wiring harnesses. |
|
|
|
|
5 | Flashes | The right motor has a short to | Contact your authorized Pride |
|
| a battery connection. | Provider. |
|
|
| |
6 Flashes | The charge inhibit has been | Make sure that the battery charger | |
|
| activated. | is not connected to the power base. |
|
|
|
|
7 | Flashes | There is a joystick fault. | Make sure the joystick is in the center |
|
|
| position and then power off and on |
|
|
| again. |
|
|
|
|
8 | Flashes | There is a control system fault. | Check power module and joystick |
|
|
| module connections and wiring. |
|
|
|
|
9 | Flashes | The park brakes have a bad | Check the left and right motor |
|
| connection. | connections and wiring. |
|
|
| |
10 Flashes | An excessive voltage has | Check the battery connections. | |
|
| been applied to the control |
|
|
| system. |
|
|
|
|
|
www.pridemobility.com | GC2 Controller |
