V I I I . A S S E M B LY A N D D I S A S S E M B LY

11.Put the batteries in place and plug the 2-pin battery harnesses into the adjoining harnesses that are also located on the control module. See figures 19 and 20.

12.Connect the battery tie-down strap.

13.If you removed the utility tray from the rear component, connect the 6-pin motor harness plug. See figure 21.

14.Gently place the rear shroud over the seat pedestal.

15.Connect the rear light harness. See figure 22. Make sure that the rear plastic shroud does not make any contact with the rear wheels.

16.Slide the shroud down in place.

17.Carefully lift the seat and slide the small seat post (on the seat bottom) into the seat post tower. See figure 23.

18.Rotate the seat until it locks into place.

Figure 20. Connect Battery Harnesses

Figure 22. Connect Rear Light Harness

Figure 19. Put Batteries in Place

Figure 21. Connect Motor Harness Plug

Figure 23. Slide the Seat into Place

28

Hurricane

Page 28
Image 28
Pride Mobility Hurricane owner manual Rotate the seat until it locks into place