I I I . Y O U R P M V
Battery Condition Meter
When the key is fully inserted into the key switch, this meter indicates the approximate battery voltage strength. For further information on battery charging, see IV. “Batteries and Charging.”
5-10 MPH Switch
This switch limits the top speed of your PMV to either 5 mph (8 km/h) or 10 mph (16 km/h). Toggle this switch to either 5 mph (8 km/h) or 10 mph (16 km/h).
NOTE: When driving indoors, it is recommended you set the switch to 5 mph (8 km/h).
Light Switch
This switch turns your PMV’s headlight on and off.
Toggle this switch to the right to turn the light on.
Toggle this switch to the left to turn the light off.
Throttle Control Lever
This lever allows you to control the forward speed and the reverse speed of your PMV up to the maximum speed you preset with the speed adjustment dial.
Place your right hand on the right handgrip and your left hand on the left handgrip.
Use your right thumb to push the right side of the lever to disengage the PMV brakes and move forward.
Release the lever and allow your PMV to come to a complete stop before pushing the left side of the lever to move in reverse.
When the throttle control lever is completely released, it automatically returns to the center “stop” position and engages the PMV brake.
REAR SECTION
The electronic controller module, batteries, main circuit breaker, power charger cord, freewheel levers, and the motor assemblies are located on the rear section of your PMV. See figures 6 and 6A.
Batteries
The batteries store the electrical energy that powers your PMV. See IV. “Batteries and Charging” for information on how to charge your PMV’s batteries.
Electronic Controller Module (Not Shown)
This module is located on the PMV’s rear section, under the utility tray cover. The controller assembly receives electrical signals from the console controls and sends power to the motor, the brakes, and the lighting system.
NOTE: Only authorized Pride service personnel should ever remove the utility tray cover.
PROHIBITED! Do not expose the electronic controller module to moisture. If it does become exposed to moisture, do not attempt to operate your PMV until it has dried thoroughly.
20 | www.pridemobility.com | Wrangler |
