V . C O M F O R T A D J U S T M E N T S

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

To change the armrest width:

1.Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 18.

2.Loosen the knobs.

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 18.

2.Loosen the jam nuts.

3.Turn the adjusting screw to raise or lower the front of the armrest.

4.Tighten the jam nuts to lock the adjusting screw into place.

SETSCREW

Figure 19. Underside of Armrest

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the controller for either left-hand or right-hand use.

WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 19.

3.Slide the controller into or out of the armrest to the desired position.

4.Tighten the setscrew to secure the controller.

To change the controller position:

1.Turn off the power to the controller.

2.Loosen the rear shroud fasteners and remove the rear shroud.

3.Unplug the controller connectors from the power base.

4.Remove any wire ties securing the controller harness to the armrest.

5.Flip up the armrest so it is perpendicular to the floor.

6.Loosen the setscrew on the controller bracket

7.Slide the controller out of the armrest.

8.Loosen the setscrew in the other armrest.

9.Place the controller in the other armrest.

10.Tighten the setscrew to secure the controller.

11.Route the controller harness to the back of the power base and plug in the controller.

12.Replace the rear shroud and tighten the fasteners.

13.Secure the controller harness to the armrest with wire ties. See figure 13.

26

www.pridemobility.com

J6 Series

Page 26
Image 26
Pride Mobility J6 2SP manual Armrest Width Adjustment, Armrest Angle Adjustment, Controller Position