V I I . O P E R A T I O N
Horn Key
The horn key activates the horn.
Locking/Unlocking the VSI
The VSI has a feature that enables you to lock your power chair to prevent unauthorized use.
To lock the VSI:
1.With the VSI switched on, press and hold the on/off key. After 1 second, the VSI should beep.
2.Release the on/off key.
3.Push the joystick to the full forward position until the VSI beeps.
4.Pull the joystick to the full rearward position until the VSI beeps.
5.Release the joystick. There should be a long beep.
6.The VSI is now locked.
To unlock the VSI:
1.Press the on/off key to power on the VSI. The maximum speed/profile indicator should ripple side to side.
2.Push the joystick to the full forward position until the VSI beeps.
3.Pull the joystick to the full rearward position until the VSI beeps.
4.Release the joystick. There should be a long beep.
5.The VSI is now unlocked.
NOTE: If the above procedure fails to either lock or unlock the VSI, contact your authorized Pride Provider.
Off-board Charger/Programming Socket
The
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the
Actuator Connector
The actuator connector connects the VSI to optional powered systems such as an elevating seat or lighting system.
Controller Connector
The controller connector connects the VSI to the power chair’s batteries, motors, and motor brakes.
Charger Inhibit Connector
The charger inhibit connector connects the VSI to the onboard battery charger. This connection provides an inhibit that disables the VSI when the battery charger is on. The charger inhibit connector is coded with colored dots. The dots are positioned so that you align the flat side of the male connector with the flat side of the female connector before making the connection.
WARNING! Failure to properly align the connectors can result in damage to the controller, the charger, and the connectors.
30 | www.pridemobility.com | Jazzy 100 |
