Pride Mobility Jazzy 1104 owner manual C O M F O R T a D J U S T M E N T S, Seat Height and Angle

V I . C O M F O R T A D J U S T M E N T S

Once you are familiar with your Jazzy’s operation, you may find the need to adjust your seating position. There are some adjustments you can make to increase your comfort, such as seat height and angle, armrest height and angle, footrest height and angle, and joystick position.

WARNING! If your Jazzy 1104 was config- ured at your authorized Pride provider or ser- vice center, please consult your health care professional before changing the seat posi- tion or making any other adjustment. Some adjustments may degrade your Jazzy’s per- formance and safety by changing its center of gravity.

SEAT HEIGHT AND ANGLE

You can change the seat height by one of two ways: either manually or automatically.

To change the seat height:

1.Remove the seat. See VII. “Disassembly” in this manual.

2.Remove the shroud.

3.Remove the ball detent pin from each seat tower. See figure 13.

4.Raise or lower each seat tower to the desired position.

5.Install the ball detent pin into each seat tower.

6.Reinstall the shroud.

7.Install the seat.

To change the seat angle:

You can change the seat angle by either raising or lowering only one set of seat towers (front or rear).

ARMREST WIDTH

To change the armrest width:

1.Locate the two knobs on the armrest receiver bracket. See figure 14.

2.Loosen the knobs and slide the armrests in or out to the desired width.

3.Tighten the knobs.

EACH SEAT

TOWER HAS A

BALL DETENT PIN

Figure 13. Seat Tower Ball Detent Pin

LOOSEN KNOBS TO MOVE ARMREST

Figure 14. Armrest Width

TURN THIS SCREW

TO CHANGE

ARMREST ANGLE

JAM NUT LOCKS

ADJUSTMENT

SCREW IN PLACE

Figure 15. Armrest Angle Adjustment

Jazzy 1104 Rev F/Feb03 www.pridemobility.com 23