V I I I . O P E R A T I O N
DYNAMIC DL CONTROLLER
The Dynamic DL controller has a speed and response adjustment knob that combines both speed and response functions. See figure 23. When you increase the speed, you decrease the sensitivity. When you decrease the speed, you increase the sensitivity.
NOTE: We recommend that you turn the speed and response adjustment knob completely counterclockwise (to the slowest setting) the first few times you operate your Jet 10. This will allow you to become familiar with your new power chair.
To operate your Jet 10:
1.Turn it on (push the on/off button). The battery condition meter will light, indicating the present charge of your battery.
2.Push the joystick in the direction you wish to move. The further you push the joystick from the center (neutral) position, the faster your Jet 10 will move.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the joystick. Unless the joystick is damaged, this action should stop your power chair.
WARNING! Unless faced with an emergency, do not use the on/off key to stop the chair. This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
BATTERYCONDITION JOYSTICK
METER
ON/OFFBUTTON
SPEED AND RESPONSE |
|
ADJUSTMENTKNOB | Figure 23. Dynamic DL Controller |
|
Battery Condition Meter
The battery condition meter is located immediately behind the joystick. This enables you to monitor battery charge. The battery condition meter indicates the approximate amount of battery charge left. See figure 23.
νRed, yellow, and green LEDs indicate that the batteries are fully charged.
νRed and yellow LEDs indicate that you should charge the batteries if possible.
νRed LEDs indicate that you should charge the batteries as soon as possible, because low battery voltage may cause your Jet 10 to become inoperative.
Jet 10/Rev H/Feb03 | www.pridemobility.com | 27 |
