V . A S S E M B L Y

To reduce the possibility of shipping damage, your Jet 10’s seat is removed from the power base. The joystick may also have been removed from the armrest. The fol- lowing is a set of instructions to help you quickly and eas- ily prepare your Jet 10 for immediate use.

SEAT INSTALLATION

CAUTION! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.

To install the seat:

Figure 7. Seat Tower

1.Set the seat on the seat tower. See figures 7 and 8.

2.Pushtheseatdownuntilthelatchengages.

3.Plug in the charger connector and the 9-pin controller connector into the power base. See figures 9 and 10. The charger connector is coded with colored dots. The dots are positioned so that the flat side of the male connector aligns with the flat side of the female connector while making the connection.

WARNING! Failure to properly align the con- nectors can result in damage to the control- ler, the charger, and the connectors.

Figure 8. Seat Installation

JOYSTICK INSTALLATION

Your Jet 10 is equipped with a Dynamic DL joystick control- ler. It may have been shipped without the joystick installed in the armrest.

To install the joystick controller:

1.Use a 3/16-in. hex key to loosen the setscrew. See figure 11.

2.Slide the joystick mounting arm into or out of the armrest bracket to the desired position.

3.Retighten the setscrew by turning it clockwise.

CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

Figure 9. Charger Connector

20

www.pridemobility.com

Jet 10/Rev H/Feb03

Page 20
Image 20
Pride Mobility Jet 10 owner manual S S E M B L Y, Seat Installation, To install the seat, Joystick Installation