Pride Mobility LX12, LX11, LX10 owner manual Toolkit, Electronic Connections

I V . Y O U R P R I D E L X

	Specifications
Drive Wheels:		33 cm solid tyres
Caster Wheels:		20 cm, solid, articulating
Anti-tip Wheels:		3.8 cm, solid, rear mounted
Maximum Speed:		6 km/hr
Brakes:		Electronic regenerative,
		“Intelligent Braking”
Ground Clearance:		11 cm
Turning Radius:		84 cm
Overall Size:		Length: 86 cm
		Width: 65 cm
Seating Options:		Sling Back and Sling Seat
Drivetrain:		Two-motor, rear-wheel-drive
Batteries:		Two 12-volt, 32 AH batteries
Range:		Up to 40 km
Battery Charger:		Off-board, 4 amp
Motor Controller:		Dynamic DL Controller
Weight Capacity:		113 kg
LX Weights:		Base: 40 kg
		Batteries: 11 kg each
Warranties:		Five-year limited warranty on frame
		Two-year warranty on drivetrain
		One-year warranty on electronics

Toolkit

Your Pride LX is equipped with a toolkit that fits inside a seatback pocket. It contains the following:

ν	socket adapter	ν	5mm hex bit	ν	4mm hex bit	ν	3mm hex bit	ν 13mm socket
ν	8mm socket	ν	socket handle	ν	10mm socket	ν	12mm socket

Electronic Connections

The Pride LX’s controller is connected to the front battery box and to each motor. See figures 15 and 16. The motor connectors are marked “L” and “R”. The “L” harness is connected to the left motor and the “R” harness is connected to the right motor.

Battery Connections: The rear battery box is connected to the front battery box via the red connector. The front battery box is connected to the controller via the black connector. Each connector is labelled with a “+” on one side and a “-” on the other side.

Main Circuit Breakers: There are two 30-amp circuit breakers that protect the electrical circuits. A circuit breaker is mounted on the side of each battery box lid. See figure 17. The circuit breaker is in-line with the positive (+) battery terminal. If the batteries and the motors are heavily strained (e.g., from excessive loads), these circuit breakers will trip to prevent damage to the motors and the electronics. If either of the circuit breakers trip, allow the Pride LX to “rest” for approximately one minute. Then, push in the circuit breaker button, turn on the controller power, and continue normal operation. If either circuit breaker continues to trip repeatedly, contact your authorised Pride Provider.

18 www.pridemobility.com AUS Pride LX Series/RevC/Apr03