V . C O M F O R T A D J U S T M E N T S
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1.Locate the two armrest knobs on each side of the arm- rest receiver bracket. See figure 14.
2.Loosen the knobs.
3.Slide the armrests in or out to the desired width.
4.Tighten the knobs.
MOUNTING | MOUNTING |
SCREWS | |
BLOCK |
|
SETSCREWS |
|
Figure 15. Controller Position - Mounting Block Shown
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 14.
2.Loosen the jam nuts.
3.Turn the adjusting screw clockwise to lower the front of the armrest, or turn the adjusting screw counterclockwise to raise the front of the armrest.
4.Tighten the jam nuts to lock the adjusting screw into place.
Controller Position
You can position the controller for either
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
To change the controller position:
1.Turn off the power to the controller.
2.Loosen the rear shroud fasteners.
3.Remove the rear shroud.
4.Unplug the controller connector(s) from the power base.
5.Cutthewiretie(s)securingthecontrollercabletothearmrest.
6.Loosenthemounting screws inthemountingblock.Seefig- ure 15.
7.Move the controller mounting block and controller to the other armrest and tighten the mounting screws.
NOTE: For contour seats, loosen the setscrew on the underside of both armrests, transfer the controller, and tighten the setscrews. See figure 16.
8.Route the controller cable to the back of the power base and plug in the controller.
SETSCREW
Figure 16. Controller Position - Underside of Armrest
Quantum 600E | www.quantumrehab.com | 25 |
