V . C O M F O R T A D J U S T M E N T S
9.Use wire ties to secure the controller cable to the seat frame.
10.Reinstall the rear shroud and tighten the fasteners.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights in
To raise or lower the foot platform:
1.Remove the quick release fasteners from the foot plat- form bracket. See figure 17.
2.Loosen the foot platform securement nut
3.Raise or lower the foot platform to the desired height.
4.Reinstall the quick release fasteners into the foot plat- form bracket and tighten.
5.Tighten the foot platform securement nut.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1.Remove the quick release fasteners from the foot plat- form bracket. See figure 17.
2.Move the foot platform securement in or out to the de- sired height
3.Reinstall the quick release fasteners into the foot platform bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See figure 18. Each quickreleasefastenerconsistsofabolt,alever,andanut.Seefigure
16.Theleverhasacamontheendthatallowsittoclampintoplace. Thequickreleasefastenerhastwostates:clampedandunclamped. When the lever is open, the quick release fastener is unclamped. Whentheleverisclosed,thequickreleasefastenerisclamped.
To clamp the quick release fastener:
1.Make sure the lever is in the open position.
2.Turn the nut clockwise until it is snug.
3.Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise
FOOT PLATFORM |
RETAINING PIN |
QUICK RELEASE |
FASTENERS |
FOOT |
PLATFORM |
BRACKET |
SECUREMENT |
NUT |
Figure 17. Foot Platform Adjustment
LEVER (FULLY CLOSED)
CAM
NUT
BOLT
UNCLAMPED | CLAMPED |
LEVER (OPEN)
Figure 18. Quick Release Fastener Operation
26 | www.quantumrehab.com | Quantum 600E |
