V I I I . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key switch before adjusting the tiller or the seat. Never attempt to adjust the tiller or the seat while the scooter is in motion.
You can adjust the tiller to many positions. The tiller adjustment lever locks the tiller in place. It has a
1.Turn the tiller adjustment lever counterclockwise until it is loose. If the tiller adjustment lever comes in contact with the tiller basket, pull it outward, turn it clockwise, and release it. Continue to loosen until the tiller is able to move. See figure 10.
2.Press the release buttons and move the tiller to a comfortable position. See figure 10A.
3.Turn the tiller adjustment lever clockwise until it is tight. If the tiller adjustment lever comes in contact with the tiller basket, pull it outward, turn it counterclockwise, and release it. Continue to turn the lever until it is tight. The tiller may be lowered to the center of the floorboard and locked in place for storage. See IX. “Disassem- bly and Assembly.”
TILLER ADJUSTMENT
LEVER
TILLER ADJUST-
MENT LEVERSLIDE LEVER OUT TO REPOSITION
TILLER BOOT
RELEASE 
BUTTONS
TILLER RELEASE
BUTTON
Figure 10. Adjusting the Tiller Angle | Figure 10A. Adjusting The Tiller Angle |
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of three different heights. See figure 11.
1.Push forward on the seat lock lever and lift the seat up and off of the scooter. See figure 12.
2.Use the attached ring to pull and remove the ball detent pin from the lower seat post.
3.Raise or lower the upper seat post to the desired seat height.
4.While holding the upper seat post at that height, match up the holes in the upper seat post with the holes in the lower seat post.
5.Fully insert the ball detent pin.
6.Replace the seat.
| LOCATING HOLES |
UPPER SEAT POST | BALL DETENT PIN |
LOWER SEAT POST |
|
Figure 11. Seat Height Adjustment
30 | www.pridemobility.com | Rally/RevF/September 03 |
