Universal Remote Control Complete Guide to Omega Universal Remote Setup for A/V Components

Universal Remote Control, Inc .

Basic Setup

You can start setting up your Omega using either the Pre-Programmed Method or the Learning Method. However, all the buttons of the Omega are setup at once with the Pre-Programmed Method, so it is usually faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

1	Power on the A/V component you wish to setup, so that you can test
	codes by sending power off commands.
2	Refer to the pre-programmed code tables on pages 37 - 52 and
	write down the code numbers listed for your A/V component. The
	code numbers are listed by categories of devices, then by brand.
	See page 37 for a category list. Code tables with model numbers
	are available at www.universalremote.com in the MX-650 area.
3	Press and hold both the MAIN and ENT (Enter) buttons for approxi-

mately three seconds. The top of the display will show “SETUP”. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If you don’t press a button within that time, the Omega will time out and return to normal operation.

MAIN	ENT
Button
	Button

5