I V . Y O U R T R A V E L S C O O T E R

BATTERY PACK

Your Travel Scooter is equipped with an innovative, easy to remove battery pack. A handle on the top of the battery pack makes it easy to lift the pack off of the Travel Scooter with one hand. The battery pack contains two batteries, the charger power cord receptacle, the main circuit breaker (reset button), and the battery pack fuse. See figure 7.

BATTERY PACK

BATTERY PACK HANDLE

 

BATTERY PACK FUSE

 

CHARGER POWER

MAIN CIRCUIT BREAKER

CORD RECEPTACLE

(RESET BUTTON)

Figure 7. Battery Pack

Charger Power Cord Receptacle

The 3-pin end of the charger power cord plugs into this receptacle.

Main Circuit Breaker (Reset Button)

When the voltage in your Travel Scooter’s batteries becomes low or the Travel Scooter is heavily strained because of excessive loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from damage.

The main circuit breaker reset button pops out when the breaker trips.

When the breaker trips, the entire electrical system of your Travel Scooter shuts down. Allow a minute or two for your Travel Scooter’s electronics to “rest.”

Push in the reset button to reset the main circuit breaker.

If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also need to have your authorized Pride Provider perform a load test on your Travel Scooter’s batteries.

If the main circuit breaker trips repeatedly, see your authorized Pride Provider for service.

TILLER CONSOLE FUSE

The fuse located under the battery pack protects the tiller console electronics. See figure 8. In the event any component of the tiller console is not responding, check this fuse. See IX. “Basic Troubleshooting” for fuse replacement instructions.

Figure 8. 3-Amp Tiller Console Fuse

20

www.pridemobility.com

Go-Go Ultra X

Page 20
Image 20
Pride Mobility SC40X owner manual Battery Pack, Tiller Console Fuse