V I I I . D I S A S S E M B L Y A N D A S S E M B L Y

ASSEMBLY

NOTE: Before attempting assembly, tilt the rear half of the Travel Scooter slightly back on the anti tip wheels as show in figure 19.

1.Use the frame release lever to lift the front section as you align the frame hooks of the front section with the lower frame tube of the rear section. See figure19.

2.Once the frame hooks are over the lower frame tube, lower the front section completely. This will engage the frame lock-up.

3.Raise the tiller and fully tighten the tiller adjustment knob.

4.Reinstall the battery pack.

5.Reinstall the seat and rotate it until it locks into place.

6.Unlock the front wheel by turning the tiller lock knob 90° counterclockwise. See figure18.

WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked position before riding your Travel Scooter.

FRAME RELEASE LEVER

FRAME HOOK

LOWER FRAME TUBE

Figure 19. Frame Separation

Go-Go Ultra X

www.pridemobility.com

31

Page 31
Image 31
Pride Mobility SC40X owner manual Assembly, Frame Separation