PrimaLuna©ProLogue Eight
5

Warning!

To prevent serious injury, electrical shock or re:
Always turn power off and disconnect power cord from unit and power source before doing
any work on unit. Do not operate with bottom plate removed. Always disconnect all cable
connections to and from preamplier before changing fuses and/or tubes.
Do not replace fuses with any fuse other than the same type and rating as used by the fac-
tory. Do not replace tubes without reading instructions. Do not replace fuses or tubes if
you have any doubt about your ability to do so. We accept no responsibility for any personal
or material damage due to incompetent use or users.

Package Contents

ProLogue Eight CD Player 1
Remote Control 1
Power Cord 1
White Gloves 1 pair
Tube Complement 2 x 5AR4
2 x 12AX7
2 x 12AU7
Main Fuse 1 x 2Amp slow blow 5 x 20mm for 100-120VAC or
1 x 1Amp slow blow 5 x 20mm for 200-240VAC

Initial Setup

Carefully remove the ProLogue Eight from its packaging. •
Use the white gloves to prevent ngerprint smudges. •
Remove the tube cage by carefully pulling it up and away from the CD player. •
Check that each tube is rmly seated in its socket. Use gloves. •
Replace cage back in its place if desired. •
Ensure that the power switch is off (down). •
Connect output of CD player with input of pre amplier or integrated amplier. •
Plug the power cord into the CD player, then into the wall socket. •
Switch the CD player on; the output will be muted for 30 seconds while the tubes •
warm up.
Switch the amplication on after the mute of the CD player is released. •
The tubes will be warmed up and ready to use in two to three minutes. And like all com-
ponents, the ProLogue Eight CD Player takes approximately 100 hours to fully break-in.
However, it is not necessary to have a CD playing to break in the player—simply leave the
unit powered up.