Assembly - General
3)Exact placement of the insert is determined by the overall shape of your fireplace opening and surround etc. First determine whether you will need leveling bolts installed or other devices to ensure a proper level instal- lation of the unit. This is determined by your fireplace construction. Sometimes the hearth is raised from the bottom of the fireplace and sometimes it is lower. Use only
On each corner of the underside of the fireplace insert there is a 3/8” NC nut welded. If required a 3/8” bolt of determined length can be threaded into these nuts to assist in leveling the unit.
NOTE: Blaze King strongly recommends that you install a complete stainless steel flue liner system. This is the safest installation and will ensure proper draft control for best burn and consistency. The aforementioned liner system is required by code for all installations in Canada, the installation codes in some USA locations do not require a full stainless steel liner system.
4)Slide the unit into the fireplace opening and attach the chimney liner or flue connector system as required, working through the opening above the unit where the top shroud panel will fit, next step. If access to the flue outlet on the insert is very restricted by fireplace opening height you may need to temporarily remove a side panel (as fitted in step 2) to allow work area to properly connect the stainless steel flue liner. Depending upon the particular installation the unit may need to be pulled out slightly from the front of the fireplace.
In some installations the leveling bolts might make it difficult to slide the unit into the fireplace, due to a rough hearth. We have provided two metal strips approximately 3" x 16" to help ease this problem. Lay the strips down and slide the unit on them, this is only a suggestion and may mot be required in all circumstances. If they are not required discard the strips. We hope they help you its a heavy job!!
Top
L
-Brackets
Brass
Screws X4
Right
Left
Screw
Figure 4
Figure 5
Screw
5)Assemble the shroud trim as shown in Fig 4. It will be attached to the unit during the next step.
6)Place the shroud top on the unit sliding it down so the tabs on the back of the part slide over the tabs on the insert.
7)Hold the shroud top panel in place and slide the trim down over the shroud sides and top (see Fig. 6). Secure the trim in place with 2 #6- 32 brass creek screws provided.
Figure 6
Page 19 | DATE PRINTED: 2/8/05 | Revision Date: 02/01/05 |
