OPERATING HEATER
FOR YOUR SAFETY 
READ BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
CAUTION: Do not try to adjust heating levels by using the equip- ment shutoff valve.
NOTICE: During initial opera- tion of new heater, logs will give off a
A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push control. Never use tools. If the appliance does not operate, don't try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.
Figure 11 - Manual ON/OFF Button Location (With access panel removed)
Figure 12 - On/Off Switch
FunctionofManualON/OFFButtonand
Power ON/OFF Switch
If your remote transmitter is lost or does not function, you can press the Manual ON/OFF Button on front of heater in order to manually operate your heater. (See Figure 11)
Note: To operate your heater the ON/ OFF switch on back of heater must be in the ON position. The RED light on the front of heater indicates there is electrical power to your heater when the ON/OFF switch is in the ON position. The GREEN light on the front of heater indicates the pilot light is ON. (See Figure 12)
Note: Please wait for one minute to light again after shutting off heater.
REMOTECONTROL 
OPERATING INSTRUCTION
Note: If operating by remote control, you must set the Control Knob on ELECTRIC position. (See Figure 11) Do not set the control knob between the locked position, otherwise there will be no power to the heater.
1.STOP! Read the safety information above.
2.Disconnect or turn off all electric power to heater.
3.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
4.Wait five (5) minutes to clear out any gas. Then smell for gas around heater including near floor. If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell gas, go to the next step.
5.Plug into a properly grounded three- prong receptacle, and install three AAA batteries in remote. A high pitch sound will occur and red power light on front of heater will be lit.
6.Make sure Control Knob is in Electric Position.
7.Point remote at bottom front of heater, press IGN/OFF button, an electric spark will ignite the pilot, and green light on front of heater will be lit.
Note: When operating heater for the first time, the ignition period may be 30 seconds or longer. This will al- low air to exit from the gas system.
Note: The pilot is located on back of front burner. If pilot does not stay lit, contact a qualified service person or gas supplier for repairs.
Note: If the 
appears on the control board, press the 
button, then press LOCK button to unlock.
11
