Profile CD7200 R

If you own a Japanese vehicle, you can use the standard ISO/DIN mounting screw holes on

the side of the CD player to attach to the existing factory mounting bracket, without using

the provided DIN sleeve.

Remove the factory ISO/DIN mounting bracket from the car along with the factory radio.

Remove the factory radio from the bracket by unscrewing the two Phillips screws on each

side of the radio paying close attention to their screw positions and saving the screws to

mount the CD player.

Remove the two spring clips from each side of the CD player by removing the screws. These

clips are not used in ISO/DIN mounting method and must be removed to expose the ISO/

DIN mounting holes.

Also remove the detachable face and rectangular trim ring from the CD player and mount the

CD player to the factory ISO/DIN bracket using the screws that you removed from the

factory radio.

Connect the wire harness and antenna plug to the back of the CD player. Then mount the

factory ISO-DIN bracket to the car.

Note: It is not necessary to attach the outer rectangular trim ring for ISO/DIN mounting method.

REMOVING THE CD PLAYER

To remove the CD player from an ISO/DIN mount, follow the above mounting procedure in

reverse order.

To remove the CD player from a sleeve mount, use the pair of keys provided.

Remove the rectangular trim ring by

applying pressure with your finger

tips, then gently pull out away from

the dash.

Insert the provided removal key into the opening on each side of the CD player.

Push the keys inward until they snap in place. Firmly grab the keys and slowly

pull the CD player out away from the dash.

PLACE FINGER TIPS HERE