ProForm 505s user manual Uprights. Make sure that the Extension Legs remain

2. With the help of another person, carefully lower the	2		69	66	64
Uprights (69) as shown. Note: It may be helpful to place
one foot on one of the Extension Legs [63] as you tip the
Uprights. Make sure that the Extension Legs remain					39
in the Uprights.
Attach each Extension Leg (63) with two 1” Tek Screws				32	57
(39) and a Round Base Pad (57) as shown. Attach the					57
		66
lower Tek Screw, without the Round Base Pad, first.
	64
		32
Attach two more Round Base Pads (57) to the base of		57
the Uprights (69) with two 1” Tek Screws (39). Note: One					39
		39	63
replacement Round Base Pad may be included. If a
Round Base Pad becomes worn and needs to be re-
placed, use the replacement Round Base Pad.
Attach the two Wheels (66) with two 2” Bolts (64) and	69	57
two Wheel Nuts (32) as shown.Do not overtighten the		39
Bolts. The Wheels should be able to spin freely.	63
With the help of another person, carefully raise the
Uprights (69) to the vertical position.
3. Identify the Right Handrail (72), which has a large round	3
hole in the location shown. Route the Upright Wire (42)
through the hole in the Right Handrail. Press a Handrail	37		71
Cap (40) onto the lower end of the Right Handrail as
shown. Attach the upper end of the Right Handrail to the					72
right Upright (69) with a 2 1/2” Bolt (37). Be careful not to
		69		Large
pinch the Upright Wire. Firmly tighten the Bolt. Attach
the lower end of the Right Handrail and the Handrail Cap			42	Hole
with a 3/4” Tek Screw (58) and a Washer (38).			37
Attach the Left Handrail (71) in the same way. Note:
There is not an upright wire on the left side.
					69
		40
	38
	58
			40
			38
			58

7