3.Place the Spa Cover (18) over the spa. Be sure that the Spa Cover is properly centered.
Snap a Buckle (2) onto each of the four latches on the Spa Cover (18).
See the inset drawing. Position one of the Buckles
(2)on the wood panels on the Spa Unit (15). Hold the Buckle in place so the strap on the Spa Cover
(18)is tight. (Note: It may be easier to position the Buckle if a second person holds the strap on the opposite side of the Spa Cover tight.) The Spa
Cover must be tight. Do not place the Buckle over one of the grooves in the wood panels.
Remove the latch. Attach the Buckle to the side of the spa with two Buckle Screws (1). Note: It may be helpful to use a drill with a 1/16Ó drill bit to make starter holes in the wood panels. You may also want to apply a little soap or wax to the screw threads.
Attach the other three Buckles (2) to the Spa Unit (15) in the same manner.
Remove the Spa Cover (18) from the Spa Unit (15).
3 |
Strap |
Latch |
2 |
15 |
1 |
18 |
15 |
2 |
4.The RESTORATION 5.1 is designed to operate with a 240 volt power source and must be wired directly to a 240 volt ground fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified electrician. Before you have the spa wired, be sure that it is in the position you want, and that it can be easily serviced, if needed.
The procedure is outlined (see WIRING THE RESTORATION 5.1 on page 10), as a reference for the quali- fied electrician. Under no circumstances should this procedure be performed by someone other than a qualified electrician.
5.After a qualified electrician has wired the spa to a 240 volt power source, wipe out the spa shell using a damp cloth. Remove the two warning decals (not shown) from the spa shell. Before you fill the spa, be sure that it is in the position you want, and that it can be easily serviced, if needed. Once the spa is filled with water, it must be drained to be moved.
Using a garden hose or other clean water source, begin filling the spa. Do not use soft water. The water temperature does not matter; however, if you use warm or hot water, the spa will be ready to use sooner. Fill the spa, until the water is about four inches below the console. Do not overfill the spa.
5 |
Fill to Here |
9
